A simple solution to the problem of holding small, thin pieces when drilling. The table has a matrix of tapped holes into which are attached clamps. The clamps hold the parts safely and securely, thus eliminating the risk of injury to the fingers. Useful for holding two or more stacked components which must be drilled exactly the same. Small table has two clamps, the larger one has four. Additional clamps are available separately. The clamps have locating grooves to enable round bar to be held.
**NEW** A set of round stainless steel bars are available to enable small radii to be formed in thin sheet metal. The set consists of bars of 5mm & 6mm diameter, which may be held under the clamps, plus bars of 8mm, 10mm, 12mm & 16mm diameter which are drilled for fixing directly to holes in the drilling table. In use, the metal to be formed is placed under a bar of appropriate diameter which is then clamped. Using a thin blade, inserted beneath the metal, the desired radius is formed by bending around the bar.
|DT6||Table size 152 x 63mm (6 x 2.5in.) Includes 2 clamps (illustrated above).||Shipped weight 0,8Kg.||£21.00|
|DT12||Table size 305 x 63mm (12 x 2.5in.) Includes 4 clamps (illustratedbelow).||Shipped weight 1,6Kg.||£33.20|
|DTC||Clamp set (2 clamps)||Shipped weight 0,25Kg||£4.90|
These photos show (l-r):
The component parts
Using small diameter bar and clamps
Forming a bend using a blade
|RFA6||Radius forming attachment for DT6||Shipped weight 0,8Kg||£15.80|
|RFA12||Radius forming attachment for DT12||Shipped weight 1.6Kg||£23.00|